Mixbus 32c crashes5/26/2023 (03-16-2020, 04:24 AM)johne53 Wrote: You need to contact Harrison directly about stuff like this. I'm quite able to complete the touch sensitive circuit and the air humidity and such is fine. The touch sensitivity seems to work fine with the other DAW's and v5. Faders go wild and chatter back and forth and the screen freezes.Īgain like I said no thinning settings change this, I retried with different faders on my device just to rule out the physical hardware. It crashed playing back the automation a couple of times but not recording it. I tried hitting the discover mackie devices button, nothing happens and again I couldnt find any info in either manual to explain how this works and what it does. I dont know any MCU controllers that use hardware midi ports to connect. The master settings asks me to connect the fw control in to fw control out, it's not possible to do this with a cable because there are no midi ports. I can't seem to get the test session to discover faders, tried the calibration option in the MCP window but there is no instructions in the manual or the ardour manual. you can see the softlcd has feedback here: Īdding a new track in the session from v5 with no grouping or vca to possibly override the controller. The black bar at the bottom of this image is my SOFTLCD, It's empty but should be showing the latest set of 8 faders i'm banked to: Ī session from v5 loaded into v6 seems to have the feedback but very buggy auto data in any write mode. I re toggled all the MCP settings and midi connections but still nothing, there is no feedback going to my tascam SOFTLCD either. My master fader is assigned to monitor by default.Īll this stuff worked fine in v5 and still does when I load it up, double checked by loading reaper. Transport and shuttle will move the playhead fine. I rebooted this test session many times over and it wont find any mackie faders. So I switched my fw1082 into midi mode and assigned it as a generic controller and wrote a passage of fader automation. Usually I could at least control the buss faders. I kept adding tracks and none of them appear to be available to bank. So I trashed config file and started a new test session and it wont find the faders at all. I hadnt changed any mackie or automation thinning settings the default setting worked fine for me on v5 in MCP or Generic midi controller. I went to write basic fader automation in touch mode today, it's not syncing correctly and it seems to want to cling to the vertical extreme end like top or bottom. I was about to start a new thread but found this, I'm on the win 10 hotfix and it's not crashing writing fader automation but it's not acting right either. Hi Dingo - I don't think it's exactly the same but there's a report on the OS-X forum which might be related. (02-16-2020, 03:38 AM)johne53 Wrote: (02-15-2020, 07:19 PM)Dingo Wrote: I have been testing v6 automation on macOS and have not had any crashes to date.
0 Comments
Leave a Reply. |